• Two fully independent RS232/TTY CURRENT LOOP serial ports with sixteen switch selectable baud rates, as well as switchable stop bit length, parity enable, parity odd/even, and   seven  or  eight  bit   word  length.
• One SERIAL STATUS port with four status bits for each serial port indicating receiver buffer full, transmitter buffer   empty,   parity error   and  over-run   error.
• Four independent PARALLEL I/O ports: 32 lines switch selectable in groups of eight as input or latched output, with an  attention  status bit  for   each  group of eight  lines.
• One separate STATUS port with a latched attention bit for each parallel port, switch  selectable to latch on a positive or negative pulse or level; with each attention status bit reset automatically by an input reference to its associated   port.
• One separate STROBE port with eight independent 500 nanosecond strobe lines, each switch selectable as a positive or  negative  strobe.
• Optionally 4K of 2114 static  RAM guaranteed   to run   at  4MHZ.
• PHANTOM DISABLE switch selection to allow PHANTOM line to disable  on  board   RAM  and   EPROM.
• Room   for  4K of  2708  EPROM  to boot!     Wait   states   insertable!  

This page was last modified on 01/08/2011